Email

Alarm video files can be sent to specific mail account through SMTP server. You must configure the email settings correctly before using it.



Table 1. Description of the buttons
Parameters Function Introduction

Enable

Check the checkbox to enable Email function.

User Name

The sender's name. It is usually the same as the account name.

Sender Email Address

Email address to send video files attached emails.

Password

The password of the sender.

Email Server

The email server IP address or host name(e.g. smtp.gmail.com).

Email Port

The default TCP/IP port for SMTP is 25(not secured). For SSL/TLS port, it depends on the mail you use.

Recipient Email Address1

Email address to receive video files.

Recipient Email Address2

Email address to receive video files.

Encryption

Check the checkbox to enable SSL or TLS if it is required by the SMTP server.

Snapshot Settings Alarm Snapshot File Name: Default(YYYY-MM-DD) /MM-DD-YYYY/ DD-MM-YYYY/ Add prefix/ Overwrite with the base file name/ Customize are available.

Timing Snapshot File Name: Default(YYYY-MM-DD) /MM-DD-YYYY/ DD-MM-YYYY/ Add prefix/ Overwrite with the base file name/ Customize are available.

Save the configuration.
Test whether the configuration is successful.
Note: You can refer to the following file name tip to customize the file name.