8.4.2.1 Region Entrance

Region entrance helps to protect a special area from potential threat of suspicious person’s or object’s entrance. An alarm will be triggered when objects enter the selected regions by enabling region entrance.



Settings steps are shown as follows:

[Detection Settings]

Note: General Settings will take effect in all detection regions/lines!

Step1: Selected detection region.

Step2: Enable region entrance detection.



[General Settings]

Step3: Set detecting sensitivity and object size limits;



Table 1. Description of the buttons
Parameters Function Introduction
Sensitivity Level 1~10 are available, the default level is 5. The higher the sensitivity, the easier it is for moving objects to be recorded in the results.
Min. Size Draw the screen or input pixel number to set the minimum size of the detected object. When the object is smaller than this size, it will not be detected. The default minimum size is 3*3.
Max. Size Draw the screen or input pixel number to set the maximum size of the detected object. When the object is larger than this size, it will not be detected. The default maximum size is 320*240.

[Schedule Settings]

Step4: Set detection schedule;



Table 2. Description of the buttons
Parameters Function Introduction
Copy the schedule area to another date.

Select all schedule.
Clear all schedule.

[Alarm Action]

Step5: Set alarm action;



Table 3. Description of the buttons
Parameters Function Introduction
Record Duration: Selected the duration time of alarm. 5s/10s/15s/20s/25s/30s are available.

Linkage: Save alarm recording files into SD Card or NAS or Upload the recording files via FTP.
Snapshot Number: The number of snapshot, 1~5 are available.

Interval: This cannot be edited unless you choose more than 1 to Snapshot.

Linkage: Save alarm recording files into SD Card or NAS, Upload the recording files via FTP and send alarm email.
External Output If the camera equips with External Output, you can enable the action after configuring the trigger duration.
Play Audio

Auto/10 seconds/30 seconds/1 minute/5 minutes/10 minutes are available.

Note: Please enable the Audio Speaker.
Alarm to SIP Phone Support to call the SIP phone after enabling the SIP function.
Note: Please open the SIP.
HTTP Notification Support to pop up the alarm news to specified HTTP URL.