8.2.1.2 HTTP



Table 1. Description of the buttons

Parameters

Function Introduction

HTTP Enable: Start or stop using HTTP.

Port: Web GUI login port, the default is 80, the same with ONVIF port.

HTTPs Enable: Start or stop using HTTPs.

Port: Web GUI login port via HTTPS, the default is 443.

Note: For more details about how to use enable HTTPS access, please refer to https://milesight.freshdesk.com/a/solutions/articles/69000797384.
Installed Certificate Upload and set the SSL certificate.
Attributes
Installation Type
Save the configuration.
Table 2. HTTP URL are as below:

Stream

URL

Main Stream

http://username:password@IP:port/ipcam/mjpeg.cgi

Secondary Stream

http://username:password@IP:port/ipcam/mjpegcif.cgi

Tertiary Stream

http://username:password@IP:port/ipcam/mjpegthird.cgi

Note: You need to change the codec type of streams to MJPEG except the main stream of H.264 cameras whose models with “-A”.