3.9.7 Access Filter

Enable Access Filter to restrict or open the access to device address added via IP or MAC.







Step1.Enable Access Filter.





Step 2.Select Filter Type.

There are two options: Deny and Allow.

Deny: Only restrict the access to the added device address.

Allow: Only open the access to the added device address.





Step 3.Add Address.

Click "Add" to add device address. You can add the address via IP or MAC.

Method 1: Add the address via IP. You can choose the IP address rule according to your needs. There are two rules: Single and Range.









Method 2: Add the address via MAC.





Step 4. Then click "Apply" to make Access Filter effective.

You can clickin the Access Filter interface to edit the corresponding address again.





Note:
  • If Access Filter is enabled and Filter type is Allow, but no address is added to the table, then no address is allowed to Access the NVR.
  • If Access Filter is enabled and Filter type is Deny, but no address is added to the table, then all addresses are allowed to Access the NVR.