Configure Devices in Bulk

For devices that support auto provision, you can configure all settings within the Profile template. This topic describes how to configure devices in bulk through Milesight Development Platform.

Restrictions

ONLY devices that meet the following requirements can be bulk configured on Milesight Development Platform:
  • Support auto provision
  • Connectivity status is NOT Offline or Banned
  • Devices of the same product model

Procedure

  1. Log in to Milesight Development Platform.
  2. On the top bar, select the Device tab.

  3. Select the devices of the same product model, then click Batch Configure.

  4. For Internet accessible devices:
    1. In the Generic Configuration tab, decide whether to connect the device to Milesight platform for remote management and configuration.
      Connect the device to Milesight Development Platform
      Retain the default settings.

      Connect the device to Milesight DeviceHub
      1. In the Connecting Platforms field, select DeviceHub 2.0.
      2. In the Milesight DeviceHub Server Address field, enter the server address of the Milesight DeviceHub.
    2. In the Basic Configuration tab, configure the device settings as needed.
  5. For Internet inaccessible devices (For example LoRaWAN sensors), in the TSL Configuration tab, configure the device settings as needed.
  6. Click Save, and in the pop-up window click OK.

Result

The configuration are updated on the selected devices.